Rear

Shock Absorber

Removal and Installation

NOTE: LH is shown, RH is similar.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the rear quarter trim panel.
3. Remove the upper shock absorber nuts, washer, and bushing.
^ To install, tighten to 18 Nm (13 ft. lbs.).
4. Remove the lower shock absorber nut, washer, and bolt.
^ To install, tighten to 175 (129 ft. lbs.).
5. Remove the shock absorber and the bushing.
6. To install, reverse the removal procedure.